Philips LX7100SA/22 - Manual (Page 44)

44
English
3139 115 22741
AMPLIFIER SECTION
Output power
- Stereo mode (DIN)
40 W + 40 W RMS 1
- Surround mode (1 kHz) 40 W RMS/channel
Frequency Response
100 Hz – 30 kHz / ±3 dB
Signal-to-Noise Ratio > 65 dB (CCIR)
Input Sensitivity
- AUX In
880 mV
- TV In 350 mV
Output Sensitivity
- Headphone
32
Ω
– 1000
Ω
- Line Out 600 mV
- Digital In acc IEC 60958 & IEC 61937
1 6ohm, 1 kHz, 10% THD
TUNER SECTION
Tuning Range FM 87.5 – 108 MHz (50 kHz)
MW 531 – 1602 kHz (9 kHz)
26 dB Quieting Sensitivity FM 20 dB
MW 3162 mV/m
Image Rejection Radio FM 25 dB
MW 28 dB
IF Rejection Ratio FM 60 dB
MW 24 dB
Signal-to-Noise Ratio FM 60 dB
MW 40 dB
AM Suppression Ratio FM 30 dB
Harmonic Distortion FM Mono 3%
FM Stereo 3%
MW 5%
Frequency Response FM 63 Hz – 10 kHz / ±6 dB
Stereo Separation FM 26 dB (1 kHz)
Stereo Threshold FM 23.5 dB
DISC SECTION
Laser Type Semiconductor
Disc Diameter 12cm / 8cm
Video Decoding MPEG-2 / MPEG-1
Video DAC 10 Bits
Signal System PAL / NTSC
Video Format 4:3 / 16:9
Video S/N 56 dB (minimum)
Composite Video Output 1.0 Vp-p, 75 Ω
S-Video Output Y - 1.0 Vp-p, 75
Ω
C - 0.286 Vp-p, 75
Ω
Audio DAC 24 Bits / 96 kHz
Frequency Response 4 Hz – 20 kHz (44.1 kHz)
4 Hz – 22 kHz (48 kHz)
4 Hz – 44 kHz (96 kHz)
Digital Output/Input SPDIF (Sony Philips digital
interface) Coaxial
- PCM IEC 60958
- Dolby Digital/DTS IEC 60958, IEC 61937
SACD D/A converter DSD
SACD cut-off frequency 30 kHz
Specifications
MAIN UNIT
Power Supply Rating 220 – 230 V; 50 Hz
Power Consumption 160 W
Eco Power Standby < 0.5 W
Dimensions (w x h x d) 390 x 73 x 360 (mm)
Weight 5.6 kg
SPEAKERS
System (front) 2-way shielded
System (rear/surround) 2-way unshielded
Impedance 6
Ω
Speaker drivers 3” full range, 1” piezo
Frequency response 120 Hz – 20 kHz
Dimensions (w x h x d) 88 x 156 x 68 (mm)
Weight 0.4 kg/each
CENTRE SPEAKER
System 2-way shielded
Impedance 6
Ω
Speaker drivers 2 x 3” full range, 1” piezo
Frequency response 120 Hz – 20 kHz
Dimensions (w x h x d) 233 x 93 x 68 (mm)
Weight 0.9 kg
ACTIVE SUBWOOFER
System Bass Reflex System
(unshielded)
Speaker drivers 6.5” woofer
Output power 100 W (4
Ω
, DIN)
THD 10% at 100 Hz
Frequency response 30 Hz – 120 Hz
Phase switch 0º, 180º
Input Sensitivity 200 mV rms
(subwoofer in)
AC power
220 – 230 V; 50 Hz
Power Consumption 53 W (at 1/8 rated power)
Dimensions (w x h x d) 210 x 210 x 360 (mm)
Weight 7.8 kg
Specifications subject to change without prior
notice
001-045-LX71-22-Eng 8/07/2003, 11:27 AM 44