NetComm NB1300PLUS4 - Manual (Page 31)

Rev. 1 - YML674 www.netcomm.com.au
NB1300Plus4 ADSL Modem Page 31
ADSL Gateway
Router - USB
Step 2: Configuring the NB1300Plus4
After connecting all the ADSL Router cables you can either configure your NB1300Plus4 using
the Easy Config software provided (Refer to page 9) or complete the following manual
configuration instructions:
a. Power on the ADSL Router and launch a web browser, such as Internet Explorer or
Netscape Navigator, browse to the address http://192.168.1.1.
b. Enter the correct user name and password to access the Configuration tool. The default user
name and password are as below.
User Name : admin
Password : password
Note: You must click the Submit button on every page that you make changes on and
when you have made all your changes click the Save Setting and Reboot button
from the bottom of the menu.
c. Click on the One Page Setup link under the Basic menu. You do not need to change the
LAN settings unless you need the NB1300Plus4 to work with an existing network on a
subnet other than 192.168.1.x.
You will need to Change your WAN and VC settings as provided by your ISP. The following
lists an example of the most common ISP settings used in Australia. The fields that require
changing from the default settings are highlighted.