National Instruments NI 9481 - Manual (Page 14)

NI 9481 Operating Instructions and Specifications 14 ni.com
Physical Characteristics
If you need to clean the module, wipe it with a dry towel.
Screw-terminal wiring ...................... 12 to 24 AWG copper
conductor wire with 10 mm
(0.39 in.) of insulation
stripped from the end
Torque for screw terminals ............... 0.5 to 0.6 N · m
(4.4 to 5.3 lb · in.)
Ferrules ............................................. 0.25 mm 2 to 2.5 mm 2
Weight............................................... 150 g (5.3 oz)
Safety
Safety Voltages
Connect only voltages that are within the following limits.
CHa-to-CHb...................................... 250 V
rms
max,
Measurement Category II
Measurement Category II is for measurements performed on
circuits directly connected to the electrical distribution system.
This category refers to local-level electrical distribution, such as