Nikon 9350 - Manual (Page 45)

2.
Install the Tripod Mount onto the back of the lens so that
it touches the flange. Secure by tightening the knob
screw.
3.
Secure the Tripod Mount to the tripod using one of the
three holes on the bottom until the system is balanced.
*The Tripod Mount base can be reversed if necessary to
balance a heavy camera system as follows: Remove the
three screws from the bottom and rotate the base 180°.
Secure the three screws back to the base and re-secure
the Tripod Mount to the 200mm Lens.
3-7