Power-up and reset conditions, Power-up and reset conditions -16 – National Instruments PXI NI 5401 User Manual
Page 23
Chapter 1
Generating Functions with the NI 5401
1-16
www.natinst.com
Power-Up and Reset Conditions
When you power up your computer, the NI 5401 is in the following state:
•
The output is disabled and set to 0 V.
•
The trigger mode is set to continuous.
•
The trigger source is set to automatic (the software provides the
triggers).
•
The digital filter is enabled.
•
Output attenuation remains unchanged from its previous setting.
•
The analog filter remains unchanged from its previous setting.
•
Output impedance remains unchanged from its previous setting.
When you reset the board using NI-FGEN or any other application
software, your NI 5401 is in the same state as shown at power up,
previously listed, with the following differences:
•
Output attenuation is set to 0 dB.
•
The analog filter is enabled.
•
Output impedance is set to 50
Ω.
•
The PLL reference source is set to internal tuning.
•
The SYNC duty cycle is set to 50%.