NETGEAR ME101 - Manual (Page 16)

5. Click OK.
6. Type the old password in the Old Password box.
7. Type a new password in the New Password box.
8. Re-type the new password in the Confirm Password box.
9. Click Apply.
10. If you are through making changes, click Logout.
Changing the Security Settings:
To have the bridge work on your network, its security settings must match those of the wireless
access point or router. You may use the browser-based configuration software to change the
WEP security settings. The default setting is to have WEP disabled. If you filled in the
parameters on page 7, you may want to refer to them for this procedure.
1. Start your browser software.
2. Type http:// followed by the IP
address for the bridge as the Web
address and press Return. (The
default is 192.168.0.200.)
You’ll see the Information page.
3. To change the password, click
Security Settings.
4. Type admin as the User ID and
type the current password as the
Password. (password is the default.)
5. Click OK.
6. Select an Encryption Length to
enable WEP security.
7. If the key is determined through software, type the phrase in the Passphrase box and click
Generate.
OR
If you entered a key manually for your wireless router or access point, select a Key and
type the hexadecimal values that are used with the wireless router or access point.
8. Click Apply.
9. If you are through making changes, click Logout.
14