NETGEAR ME101 - Manual (Page 8)

Connecting Multiple Devices
1. Turn off the gaming console(s) and other Ethernet-enabled device(s).
2. Connect the provided Ethernet cable between the ME101 Wireless Bridge and a hub.
3. Connect the powered down game console(s) and the powered down Ethernet-enabled
device(s) to the hub.
4. Connect the power adapter to the wireless bridge and plug the power adapter in to a
power outlet. The Power and Wireless LAN lights should light up.
5. Connect the power adapter to the hub. Plug the hub’s power adapter in to a power outlet.
6. After the Wireless light on the bridge lights up, turn on any game console(s).
7. Turn on any other Ethernet-enabled devices.
If the bridge and the Ethernet-enabled device(s) are successfully connected, the Network
light on the bridge will light up. This light flashes when there is network activity.
Note: If your setup works with the default settings, you don’t need to install the software
from the provided CD to configure the bridge unless you need to change the
Country/Region setting from the default setting (U.S.A.) or you have more than one
ME101 bridge on your network.
Default Ethernet Antenna DC in 5V
1 2 3 4
10 BASE-T HUB EN104 Link Rx
Normal / Uplink
PWR
COL
Wireless Router
MR814
Cable or
DSL modem
ME101 Wireless
Ethernet Bridge
EN104TP Ethernet Hub
Gaming console or other
Ethernet-enabled device
PC
6