Niles Audio DMS4 - Manual (Page 12)

12
REmOTE CONTROl usE IN a mulTI-
ROOm sYsTEm
Your IntelliControl ® ICS DMS4 Digital Music Server remote
control can be configured so that every button press indicates
to the system which output is to be controlled. This means
that whenever infrared is received by the DMS4 Digital Music
Server the TV display will automatically switch to controlling the
appropriate output.
To configure the remote controller with a default output
Press the Audio Server and OSelect keys simultaneously
on the remote control; hold them down for 1 second
The Audio Server key will remain lit for 20 seconds; the
configuration process must be completed during this time.
Enter the 3 digit code into the hand-held remote control
corresponding to the output you would like to control (valid
configurations are listed in Appendix A). For example, to
set output 2 as your default output press:
0, 0, 2
Press the remote’s Audio Server button again
The Audio Server button will blink twice to indicate that the
configuration has been accepted. If the Audio Server button
does not blink twice begin the process again, taking care to
enter the number correctly.
Pressing any navigation key on the remote should now cause
the DMS4 Digital Music Server to switch to the correct output.
The remote control can still be used to control a different audio
output in the normal way; pressing the Home Output key will
return it to controlling the default output.
vOlumE CONTROl vIa THE REmOTE
In addition to controlling the volume with the IntelliContol ®
system, your DMS4 Digital Music Server remote control is
capable of controlling the volume of the music you are listening
to. This is done either by controlling the output of the DMS4
Digital Music Server itself, or by reassigning the volume control
keys to control the output of your amplifier. Ignore this section if
your installer has installed your system such that volume settings
are entirely controlled by your in-wall or hand-held IntelliControl ®
system.
Controlling the Volume of the DMS4 Digital Music
Server Directly from the Remote
Each audio output must be configured individually to allow its
volume to be controlled by the remote control.
Controlling the volume of an output
Navigate to the Settings menu
Use the U and V keys to select Output Configuration
and press OSelect
Use the U and V keys to select an audio output and
press OSelect
From the menu that appears choose Volume and press
O Edit
Select Variable and press MSave
The rVolume and sMute keys on the remote control will
now control the volume of the chosen audio output.
Reassigning the Remote’s Volume Control to the
Amplifier Output
The rVolume and sMute keys on the remote control can
be configured to control the volume on your amplifier while the
Audio Server device is selected.
To reassign volume control
•
•
•
•
•
•
•
•
Ensure the Amp device is correctly configured to control
your amplifier (as described in Configuring Your Remote
to Control Other Devices on page 11)
Press the Audio Server and OSelect keys simultaneously;
hold them down for 1 second
The Audio Server key will remain lit for 20 seconds; the
configuration process must be completed during this time.
Press the sMute key
Press the rVolm key
Press the Amp device key
The Audio Server device key will blink twice to indicate that
the configuration has been accepted. If the Audio Server key
does not blink begin the process again, taking care to press the
buttons in the correct sequence. The rVolume and sMute
keys should now control the amplifier when the Audio Server
device is selected.
To return the rVolume and sMute keys to their original
configuration repeat the above process, press the Audio Server
key instead of the Amp key.
•
•
•
•
•