Niles Audio DMS4 - Manual (Page 13)

13
www.nilesaudio.com
CONNECTING
YOUR DMS4 DIGITAL
MUSIC SERVER
BasIC CONNECTIONs
The diagram below illustrates the basic connections required to
use your DMS4 Digital Music Server.
Note: Do not make any connections to the DMS4 Digital Music
Server while the power supply is connected and switched on.
Connecting the Audio
Connect a stereo RCA audio cable to the Analog Out 1
connectors on the rear of the DMS4 Digital Music Server.
Connect the other end of this cable to an appropriate
input on your pre-amplifier. In the same way connect the
other Analog Out connectors to other stereo amplifiers as
appropriate. Subsequently, connect the pre-amplifier to
your stereo amplifier
Connecting the Video
Connect the yellow plug of the supplied composite video
cable to the yellow Video Out socket of the DMS4 Digital
Music Server. For most TVs connect the other end of this
cable to the ext. 1 or 2 socket on the rear of your TV. For
some TVs it may be necessary to use a SCART plug. In
this case connect the other end of this cable to the yellow
socket on the SCART plug. Now connect the SCART plug
to the SCART socket in the rear of the TV
•
•
Connecting to the Internet
Connect an Ethernet cable to a free Ethernet socket on
your network device or broadband router. Connect the
other end of this cable to the socket marked Ethernet on
the back panel of the DMS4 Digital Music Server
Connecting the Power
Connect the supplied power cord to your power supply.
Note: be sure to use the correct power cord for your country
Switching On
Switch on your DMS4 Digital Music Server using the
button labelled STANDBY on the front panel
Switch on your television. Select the appropriate video
channel to view the DMS4 Digital Music Server TV User
Interface display
Your DMS4 Digital Music Server is now connected and
ready for use. To take advantage of the DMS4 Digital Music
Server’s multi-room functionality, refer to the section overleaf
entitled Integrating the DMS4 Digital Music Server into an
Intellicontrol ® ICS System
Note: In order to connect to the Internet in the below example it
will be necessary to configure the DMS4 Digital Music Server’s
settings to connect using Ethernet. See the Quick Start Guide
for more information.
•
•
•
•
Fig. 2-1 Basic connectivity of a DMS4, network router, amplifier and TV