Precautions – Niles Audio DMS4 User Manual

Page 4

Advertising
background image

4

PRECAUTIONS

GENERal PRECauTIONs

When installing the equipment ensure that:

it is not moved while in operation
the ventilation holes are not covered
air is allowed to circulate freely around the equipment
it is placed on a vibration free surface
it will not be exposed to excessive heat, cold, moisture or

dust
it will not be exposed to direct sunlight
it will not be exposed to electrostatic discharges
it is not installed vertically or tilted
never place heavy objects on the equipment

If a foreign object or water does enter the equipment, contact

your nearest dealer or service center.
It is advisable when leaving the house, or during a thunderstorm,

to disconnect the equipment from the power supply.

waRNINGs

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO

NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
Do not remove the cover from the equipment. There are

no user serviceable parts inside, and opening the case will

invalidate your warranty.
Do not move while the product is running. Movement can

result in irrecoverable data loss and damage to the hard disk.

Allow at least 30 seconds after shutdown before moving to

allow the hard disk to spin down.
Do not pull out the plug by pulling on the power cord; grasp

the plug.
Do not insert anything into the equipment through the

ventilation holes.
Do not cover the ventilation holes with any items such as

tablecloths, newspapers, curtains, etc. To avoid overheating

do not position the DMS4 Digital Music Server near or above

heat sources, and ensure that the ventilation holes are not

blocked.
Do not place naked flame sources, such as lighted candles,

on the equipment.
Do not handle the power lead with wet hands.
At least 2.5cm/1” clearance is required on all sides to allow

air to circulate in and around the product.
Do not splash or spill water on the unit. Do not place objects

filled with liquid (such as vases) on the unit.

Cd HaNdlING PRECauTIONs

Handle discs carefully so as not to damage or scratch the

front side. Always keep the disc surface clean
To protect the disc avoid placing it in the following

locations:

In direct sunlight or near a source of heat
In a place which is damp or dirty
In a place which could be exposed to rain, such

as near a window

Do not use a disc with a special shape
For best performance when recording from a CD ensure the

temperature never exceeds 35°C/95°F where the DMS4

Digital Music Server is located

dTs ENCOdEd dIsCs PRECauTION

CAUTION - when playing DTS encoded discs excessive noise will

be heard on the analog output jacks of the DMS4 Digital Music








-
-
-


Server. To avoid possible damage to the system you should ensure

that the correct connections are made to your amplification system for

replaying this type of disc.

POwER CORd PRECauTIONs

Your DMS4 Digital Music Server complies with the household

power and safety requirements in your area.

IMPORTANT IF USED IN THE UK:

This apparatus is fitted with an approved moulded 13 amp

plug. To change a fuse in this type of plug proceed as follows:

Remove fuse cover and fuse
Fix new fuse which should be a BS1362 5A, A.S.T.A or

BSI approved type
Refit the fuse cover

If the fitted plug is not suitable for your socket outlets, it should be cut

off and an appropriate plug fitted in its place.
If the power plug contains a fuse, this should have a value of

5A. If a plug without a fuse is used, the fuse at the distribution

board should not be greater than 5A.
Note: The severed plug must be destroyed to avoid a possible

shock hazard should it be inserted into a 13A socket elsewhere.

How to connect a plug

The wires in the power lead are colored in accordance with the

following code:

The BLUE wire must be connected to the terminal which is

marked with the letter “N” or colored BLACK
The BROWN wire must be connected to the terminal which

is marked with the letter “L” or colored RED
The GREEN/YELLOW-GREEN wire must be connected

to the terminal which is marked by the letter “E” or by the

safety earth symbol

or colored green or green-and-

yellow

Before replacing the plug cover, make certain that the cord grip

is clamped over the sheath of the lead - not simply over the three

wires.

BaTTERY PRECauTION

This product contains a lithium battery. Danger of explosion

if battery is incorrectly replaced. Replace only with the

same or equivalent type recommended by Niles. When

disposing of used batteries, please follow the manufacturer’s

recommendations and comply with governmental regulations or

environmental regulations or environmental public instructions

that apply in your country or area.

sTaNdBY BuTTON

When this button is pressed once, the power turns On and

information will appear on the display. When pressed again,

press the Off action key or the ; key on the remote control

to switch to Off mode. When the unit is in Off mode the

“Standby” indicator is lit; the apparatus is not disconnected from

the AC power supply in this mode.

COPYRIGHT NOTICE

This equipment must not be used for unauthorized duplication

of CDs or any other works protected by copyright. No license

to infringe copyright is granted by the sale of this equipment.
Recording and playback of some material may require

permission. For further information refer to the following:

Copyright Act 1956
Dramatic and Musical Performers Act 1958
Performers Protection Acts 1963, and 1972
Any subsequent statutory enactments and orders

1.
2.

3.

1.

2.

3.




Advertising