Niles Audio DMS4 User Manual

Page 9

Advertising
background image

9

www.nilesaudio.com

REaR vIEw

IR RECEIVER

The IR Receiver connection allows remote control information

to be carried from other devices directly into the DMS4 Digital

Music Server.

CONTROLLER

The Controller port provides serial communication with

supported devices.

USB

Allows the DMS4 Digital Music Server to communicate with

supported USB devices.

ETHERNET

The Ethernet port is used to connect the DMS4 Digital Music

Server to a high speed Internet connection.

VGA

The VGA connector may be used to connect a VGA monitor.

VIDEO OUT

Connect the composite Video Out of the DMS4 Digital Music

Server to the composite input of a suitable PAL/NTSC TV

(depending on the supplied configuration) to display the TV

User Interface. You may also need to switch the TV to the

relevant AUX input to display the picture.

S-VIDEO OUT

Connect the S-VIDEO output of the DMS4 Digital Music Server

to the S-VIDEO input of a suitable PAL/NTSC TV (depending

on the supplied configuration) to display the TV User Interface.

You may also need to switch the TV to the relevant AUX input to

display the picture.

DIGITAL OPTICAL IN

Reserved for future use.

DIGITAL OPTICAL OUT

The digital optical output can be used to transmit high quality

audio to a device with a digital optical input (D/A converter,

A/V amplifier etc.) using an optical fiber cable without first

being converted to analog. Audio sent via this output is the

same as that sent via the Analog Audio Out 1 connector.

DIGITAL OUT - COAXIAL

By connecting this jack to a digital audio component (D/A

converter, A/V amplifier etc.), digital signals from the DMS4

Digital Music Server can be transmitted directly from the system

without first being converted to analog. Audio sent via this

output is the same as that sent via the Analog Audio Out 1

connector.

DIGITAL IN - COAXIAL

Reserved for future use.

ANALOG IN

Analog sources (such as cassette or vinyl LP) may be recorded

onto the hard disk of the DMS4 Digital Music Server using this

connection. (Not yet supported in the current software release).

ANALOG OUT 1,2,3,4

The DMS4 Digital Music Server is a multi-room device allowing

you to listen to different music in up to four different zones all

at the same time (depending on the configuration purchased).

Each analog output should be connected to the input jacks of a

pre-amplifier.

POWER

Connect the supplied power cord to this connector to provide

power to the unit.

Fig. 1-2 DMS4 Rear Panel

Advertising