Hardware installation – NetComm NP5410 User Manual
Page 8
www.netcomm.com.au
Rev. 1 - YML675
Page 8
NP5410 Wireless Ethernet Bridge User Guide
Hardware Installation
Following illustration is an example showing how to install the NP5410 with your PC. You will
need to connect the NP5410 in this way to configure the setting before connecting the bridge to
your target network, games console or PC.
Be sure to use the supplied power adapter.
1. Connect your NP5410 to a computer or switch directly using the supplied Cat-5 ethernet
cable.
Note:
The LAN Cable Selection Switch should be set to “II” or “X” depending on the
type of connection required. Refer to the section on the rear panel.
2. Connect the power pack to the NP5410 and switch on the power.
3. Ensure that there is a LAN link light on the NP5410. If not, try changing the crossover
selection switch.
4. Ensure that the computer you intend to use has an IP address in the same subnet as the
NP5410. (192.168.1.100)
Note:
You may also connect the NP5410 to another Ethernet-ready device, such as a
printer server.