National Instruments NI-488.2 - Manual (Page 28)

Chapter 2 Measurement & Automation Explorer (Windows)
NI-488.2 User Manual 2-14 ni.com
3. Right-click on your GPIB-ENET/100 interface and select Device
Configuration from the drop-down menu that appears.
For more information about the NI Ethernet Device Configuration utility,
refer to the GPIB-ENET/100 information in the GPIB Hardware Guide.
Update GPIB-ENET/100 Firmware
You can run the Firmware Update utility in Measurement & Automation
Explorer, as follows:
1. Start Measurement & Automation Explorer as described in the
Starting Measurement & Automation Explorer section.
2. Expand the Devices and Interfaces directory by clicking the + next
to the folder.
3. Right-click on your GPIB-ENET/100 interface and select Update
Firmware from the drop-down menu that appears.
For more information about the Firmware Update utility, refer to the
GPIB-ENET/100 information in the GPIB Hardware Guide.