National Instruments NI-488.2 - Manual (Page 72)

Chapter 7 Interactive Control Utility
© National Instruments Corporation 7-9 NI-488.2 User Manual
Table 7-3. Syntax for Multi-Device NI-488.2 Calls in Interactive Control
Syntax Description
AllSpoll addrlist Serial poll multiple devices.
DevClear address Clear a device.
DevClearList addrlist Clear multiple devices.
EnableLocal addrlist Enable local control.
EnableRemote addrlist Enable remote control.
FindLstn padlist limit Find all Listeners.
FindRQS addrlist Find device asserting SRQ.
PassControl address Pass control to a device.
PPoll Parallel poll devices.
PPollConfig address dataline
lineSense
Configure device for parallel poll.
PPollUnconfig addrlist Unconfigure device for parallel poll.
RcvRespMsg count termination Receive response message.
ReadStatusByte address Serial poll a device.
Receive address count termination Receive data from a device.
ReceiveSetup address Receive setup.
ResetSys addrlist Reset multiple devices.
Send address buffer eotmode Send data to a device.
SendCmds buffer Send command bytes.
SendDataBytes buffer eotmode Send data bytes.
SendIFC Send interface clear.
SendList addrlist buffer eotmode Send data to multiple devices.
SendLLO Put devices in local lockout.
SendSetup addrlist Send setup.
SetRWLS addrlist Put devices in remote with lockout state.
TestSRQ Test for service request.