NorthStar Navigation 8000I - Manual (Page 70)

70 Northstar 8000i Black Box Processor
5. Select OK to confirm the new name. The 8000i restarts with the new name. The
setting stays until you change it again.
10.13 Set the screen resolution
The screen resolution can be changed on the 8000i Black Box Processor to match the
monitor it is attached too. Default is 1024 x 768. Other options are 800 x 600 and 1280 x 720.
If you change the screen resolution, the 8000i must be restarted to apply the new setting.
To set the screen resolution:
1. Select Display .
2. Select Setup from the control panel.
3. Select + System to display a list of system specification options.
4. The Screen Resolution button shows the current setting. Select the button if you
want to change the setting and a drop down list of choices appears.
5. Select the new setting and select OK to confirm. The 8000i restarts with the new
screen resolution. The setting stays until you change it again.
6. When you are finished, select – System .
10.14 Set the units
10.14.1 Select the speed units
You can select from Knots, mph, or kph for speed units. Knots is the default.
To select the speed units:
1. Select Display .
2. Select Setup from the control panel.
3. Select + Units to display a list of unit specification options.
4. The Speed Units button shows the current setting. Select the button if you want to
change the setting and a drop down list of choices appears.
5. Select the new setting. The new setting is applied immediately and stays until you
change it again.
6. When you are finished, select – Units .
10.14.2 Select the depth units
You can select from Feet, Meters, or Fathoms for depth units. Feet is the default.
To select the depth units:
1. Select Display .
2. Select Setup from the control panel.
3. Select + Units to display a list of unit specification options.
4. The Depth Units button shows the current setting. Select the button if you want to
change the setting and a drop down list of choices appears.
5. Select the new setting. The new setting is applied immediately and stays until you
change it again.
6. When you are finished, select – Units .
10.14.3 Select the pressure units
You can select from PSI, Bar, or hPa for pressure units. PSI is the default.
To select the pressure units:
1. Select Display .