Nortel Networks C4030 - Manual (Page 5)

7
C 4 0 3 0 H a n d s e t S t a n d a r d 1 .0 0
Wall mounting the Charger: 1. Drill two holes into the wall, with
vertical spacing of 65 mm, and insert
the screws.
2. Plug the power cable into the
charger.
3. Hang the charging unit on the
screws.
4. Plug the power cable into the wall
socket.
5. Place the telephone handset on the
charger.
Note: Only use the charging unit supplied with the device.
Installing and replacing batteries
Read the following information before you handle the batteries.
• Heat or cold reduces the performance and service life of batteries.
A handset with hot or cold batteries can temporarily fail to operate, even if
the batteries are fully charged. Keep battery temperature between 15 C
and - 25C.
• Dispose of used batteries in accordance with local authority regulations.
Do not dispose of batteries in fire.
Two rechargeable NIMH batteries (type AAA/RO3 1.2 V / 650 mAh) power the
handset.
• Replace batteries with NTTQ00AA.
• Never use damaged, worn out, or non-rechargeable batteries.
• Only use stated battery type and recommended vendor models.
• The manufacturer disclaims responsibility if these recommendations are
not followed!