NetComm NP7042 - Manual (Page 8)

www.netcomm.com.au Rev.1 - YML654
Page 8 NP7042 - Wireless LAN USB Adaptor
Installation
The physical installation for the NetComm NP7042 - Wireless LAN USB Adaptor amounts to
simply plugging the unit's USB cable into an available USB port on a USB enabled computer.
The NetComm NP7042 - Wireless LAN USB Adaptor should then be located such that the
minimum number of obstructions such as walls, floors, ceilings, and office equipment are
between it and the nearest access point.
Preparation
Before beginning the installation, verify the hardware package contains the NetComm NP7042 -
Wireless LAN USB Adaptor. Keep the serial number in a safe place. The Support Centre uses
this information to reference warranty and service contract information.
Note: Verify the model indicated on the adaptor and packaging before use. Contact the
Support Centre if an item is missing or not functioning.
Requirements
The NetComm NP7042 - Wireless LAN USB Adaptor installation requires:
■
a computer with an available USB port.
■
a CD-ROM drive or Internet access.
■
Microsoft Windows 98, Millennium (ME), Windows 2000 or Windows XP
Avoid exposing the NetComm NP7042 - Wireless LAN USB Adaptor to liquids or
abrasive materials.