National Instruments GPIB-COM User Manual
Gpib-com, User manual
Advertising
Table of contents
Document Outline
- GPIB-COM User Manual
- Important Information
- FCC/DOC Radio Frequency Interference Compliance
- Preface
- Contents
- Section One Introduction
- Section Two Configuration and Installation
- Section Three Function Description
- Section Four Running Diagnostic Tests
- Section Five Programming the GPIB-COM
- The GPIB-COM Registers
- Transmitter Holding Register
- Receive Buffer Register
- Divisor Latch Least Significant Byte (LSB) Register
- Divisor Latch Most Significant Byte (MSB) Register
- Interrupt Enable Register
- Interrupt Identification Register
- Line Control Register
- Modem Control Register
- Line Status Register
- Modem Status Register
- Programming the Serial Adapter
- The GPIB-COM Controller Function
- The GPIB-COM Registers
- Appendix A Specifications
- Appendix B Multiline Interface Command Messages
- Appendix C Operation of the GPIB
- User Comment Form
- Figures
- Figure 1-1. GPIB-COM Board
- Figure 2-1. GPIB-COM Parts Locator Diagram
- Figure 2-2. Possible Settings for GPIB-COM Jumpers
- Figure 2-3. Jumper W1 Settings
- Figure 2-4. Switch Setting for REN* OFF, IFC* ON, SRQ* ON, and Listen Address 5 (Default Settings)
- Figure 2-5. Listen Address Setting for Listen Address 10 Hex
- Figure 2-6. Switch Setting for REN* ON, IFC* OFF, and SRQ* OFF
- Figure 3-1. Block Diagram of GPIB-COM
- Figure 4-1. Plotter Output
- Figure C-1. GPIB Cable Connector
- Figure C-2. Linear Configuration of the GPIB Devices
- Figure C-3. Star Configuration of GPIB Devices
- Tables