National Instruments SC-2040 - Manual (Page 54)

Index
SC-2040 User Manual Index-2 © National Instruments Corporation
procedure for, 2-6 to 2-7
switch settings (table), 2-7
table, 2-5
channel input mode (table), 2-5
CH+(0..7) signal (table), 3-4
common-mode input range, 3-10 to 3-11
configuration
channel gain selection
gain switches for each channel
(table), 2-6
procedure for, 2-6 to 2-7
switch settings (table), 2-7
table, 2-5
channel input mode (table), 2-5
DAQ board ground isolation selection
procedure for, 2-6
table, 2-4
input mode selection, 2-7
parts locator diagram, 2-2
power supply selection
procedure for, 2-6
table, 2-3
shield selection
procedure for, 2-4
table, 2-4
connectors J11 and J12
overview, 3-1
pin assignments (illustration), 3-2
(table), 3-3
signal routing (illustration), 3-6
signal summary (table), 3-4
customer communication, xi, B-1
D
DAQ board ground isolation selection
procedure for, 2-6
table, 2-4
DC-coupled inputs, 3-7 to 3-8
floating signal connection
(illustration), 3-8
ground-referenced signal connection
(illustration), 3-7
leaving connector J5 disconnected
(note), 3-7
DGND signal
input connector summary (table), 3-4
output connector summary (table), 3-4
to 3-5
digital signal inputs, 3-9
documentation
conventions used in manual, x
National Instruments documentation
set, x
organization of manual, ix
related documentation, xi
E
environment specifications, A-3
equipment, optional, 1-4
EXT switch position (table), 2-3
F
floating AC-coupled signal connection
(illustration), 3-10
floating signal connection (illustration), 3-8
G
gain selection. See channel gain selection.
ground-offset AC-coupled signal connection
(illustration), 3-9
ground-referenced AC-coupled signal
connection (illustration), 3-9
ground-referenced signal connection
(illustration), 3-7
H
hardware calibration.
See calibration procedures.
hold-mode settling time, 4-3
I
input connectors signal summary (table), 3-4
input mode selection, 2-7
installation
power-on sequence, 2-8
steps for, 2-8