National Instruments HPC167064 - Manual

TL DD11046
HPC167064HPC467064
High-Performance
microController
with
a
16k
UV
Erasable
CMOS
EPROM
PRELIMINARY
August 1992
HPC167064 HPC467064 High-Performance
microController with a 16k UV Erasable CMOS EPROM
General Description
The HPC167064 is a member of the HPC family of High
Performance microControllers Each member of the family
has the same core CPU with a unique memory and I O
configuration to suit specific applications The HPC167064
has a 16 kbyte high-speed UV-erasable electrically pro-
grammable CMOS EPROM This is ideally suited for appli-
cations where fast turnaround pattern experimentation and
code
confidentiality are important requirements The
HPC167064 can serve as a stand-alone emulator for either
the HPC16064 or the HPC16083 Two configuration regis-
ters have been added for emulation of the different chips
The on-chip EPROM replaces the presently available user
ROM space The on-chip EPROM can be programmed via a
DATA I O UNISITE There are security features added to
the chip to implement READ ENCRYPTED READ and
WRITE privileges for the on-chip EPROM These defined
privileges are intended to deter theft alteration or uninten-
tional destruction of user code Each part is fabricated in
National’s advanced microCMOS technology This process
combined with an advanced architecture provides fast flex-
ible I O control efficient data manipulation and high speed
computation
The HPC devices are complete microcomputers on a single
chip All system timing internal logic EPROM RAM and
I O are provided on the chip to produce a cost effective
solution for high performance applications On-chip func-
tions such as UART up to eight 16-bit timers with 4 input
capture registers vectored interrupts WATCHDOG
TM logic
and MICROWIRE PLUS TM provide a high level of system
integration The ability to address up to 64k bytes of exter-
nal memory enables the HPC to be used in powerful appli-
cations typically performed by microprocessors and expen-
sive peripheral chips
The microCMOS process results in very low current drain
and enables the user to select the optimum speed power
product for his system The IDLE and HALT modes provide
further current savings The HPC167064 is available only in
68-pin LDCC package
Features
Y HPC family core features
16-bit architecture both byte and word operations
16-bit data bus ALU and registers
64 kbytes of direct memory addressing
FAST
200 ns for fastest instruction when using
20 0 MHz clock 134 ns at 30 0 MHz
High code efficiency
most instructions are single
byte
16 x 16 multiply and 32 x 16 divide
Eight vectored interrupt sources
Four 16-bit timer counters with 4 synchronous out-
puts and WATCHDOG logic
MICROWIRE PLUS serial I O interface
CMOS
very low power with two power save modes
IDLE and HALT
Y 16 kbytes high speed UV erasable electrically program-
mable CMOS EPROM
Y Stand-alone emulation of HPC16083 and HPC16064
family
Y EPROM and configuration bytes programmable by
DATA I O UNISITE with Pinsite Module
Y Four selectable levels of security to protect on-chip
EPROM contents
Y UART full duplex programmable baud rate
Y Four additional 16-bit timer counters with pulse width
modulated outputs
Y Four input capture registers
Y 52 general purpose I O lines (memory mapped)
Y Commercial (0 C to a70 C) and military (b55 C to
a 125 C) temperature ranges for 20 0 MHz commercial
(0 C to a70 C) for 30 0 MHz
Block Diagram
(HPC167064 with 16k EPROM shown)
TL DD 11046 – 1
Series 32000 and TRI-STATE are registered trademarks of National Semiconductor Corporation
MICROWIRE PLUS TM and WATCHDOG TM are trademarks of National Semiconductor Corporation
UNIX is a registered trademark of AT T Bell Laboratories
IBM and PC-AT are registered trademarks of International Business Machines Corp
SunOS TM is a trademark of Sun Microsystems
C1995 National Semiconductor Corporation RRD-B30M105 Printed in U S A