NordicTrack NTL22907.1 - Manual (Page 11)

11
If you purchase the optional chest pulse sensor (see page 25), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove the indicated Screws (7) from the back
of the Console Base (98).
2. While a second person holds the console as-
sembly, connect the wire on the receiver (A) to
the indicated wire extending from the Console.
Next, hold the receiver so the small cylinder
is oriented as shown and is facing away from
the Console. Attach the receiver to the Console
in the location shown with the two included Small
Screws (B).
3. Make sure that no wires are pinched. See
drawing 1. Reattach the Console (105) to the
Console Base (98) with the Screws (99). Discard
the other wires included with the receiver.
7
98
7
Console Assembly 1
7 7
7 7
7
Wire
98
Cylinder
105
A
2
B