NordicTrack NTL22907.1 - Manual (Page 7)

7
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex key and your own phillips screwdriver , standard
screwdriver , and rubber mallet . For help identifying the assembly hardware, see
the drawings below. The number in parentheses below each drawing is the key number of the part, from the
PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assem-
bly.
Note: Some small parts may have been preassembled. If a part is not in the parts bag, check to see if it
has been preassembled. To avoid damaging plastic parts, do not use power tools for assembly. Extra
hardware may be included.
1/2” Silver Screw
(48)–1
3/4” Tek Screw (58)–4
3
Spacer Screw (60)–2
1
(87)–4
Star Washer (67)–4
Screw (7)–2 1” Tek Screw (82)–4
Cage Nut (70)–3
P
Base Plate Bolt (77)–3 Handrail Bolt (72)–4
1” Tek Screw (82)
70
20
1
70
1. With the help of a second person, tip the
Uprights (20) down as shown.
Insert the three Cage Nuts (70) into the three in-
dicated holes in the treadmill. To insert each
Cage Nut, first hook one side of the Cage Nut
into a hole. Then, use a standard screwdriver to
press the other side of the Cage Nut into the
hole, as shown.