NordicTrack NTL22907.1 - Manual (Page 8)

3. With the help of a second person, carefully raise
the Uprights (20) to the vertical position. Remove
the band securing the Upright Wire Harness (73)
to the right Upright. Have a second person hold
the console assembly near the right Upright.
Connect the Upright Wire Harness (73) to the
console wire extending from the console assem-
bly.
See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again.
IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON. Then, insert the connectors into
the right Upright (20).
Connect the TV Cable (not shown) in the left
Upright (not shown) to the cable extending from
the console assembly.
3
20
81
82
81
81
81
Console Wire
82
82
2
82
2. Attach the four Base Pads (81) to the base of the
Uprights (20) with four 1" Tek Screws (82) in the
locations shown.
73
20
73
8
4. Connect the TV Cable (117) in the left Upright
(20) to the cable extending from the console as-
sembly.
4
117
20
Console Assembly
Console
Assembly