N-Tron 102RAS - Manual (Page 7)

(Revised 2010-11-15) page 7 of 30
DIN Rail Mounting
Install the unit on a standard 35mm DIN rail. Recess the unit to allow at least 3” of horizontal clearance for
cable bend radius.
To mount the unit to the 35mm DIN rail,
place top edge of the brackets on the back of the
unit against the DIN rail at a 45° upward angle.
Lower the bottom of the unit until it snaps into
place on each bracket
.
To remove the unit from the 35mm DIN rail, typically
it is possible to remove the unit by using your index and
middle fingers or use flat head screwdrivers placed into
each of the release clips at the bottom of the unit to push
down on each clip until they disengage the bottom of the
unit from the DIN rail. Lift the bottom of the unit up at
an approximate 45° upward angle to completely remove
the unit.
Most N-Tron™
products are
designed to be mounted on industry
standard 35mm DIN rail. However,
DIN rail mounting may not be
suitable for all applications. Our
Universal Rack Mount Kit (P/N:
URMK) may be used to mount the
102RAS to standard 19" racks as an
option.