Nortel Networks Passport 241-5101-200 - Manual (Page 38)

38 Chapter 4 Configuring the Passport 8250 for operations
241-5101-200 R2.2
a. For each power supply module, turn the power supply breaker to ON.
The LEDs on each power supply module is on.
Text is displayed on the hyperterminal screen.
3 From the hyperterminal session, stop the Passport 8250 device from
starting-up:
a. Press the return key within three seconds of the following text
displaying on the screen:
PRESS ANY KEY TO CONFIGURE BOOT PARAMETERS.
4 From the hyperterminal session, log into the CLI:
a. Press the return key until the username prompt is displayed on the
screen.
b. At the username prompt, type admin.
admin is the permanent userid for CLI sessions, Telnet sessions, and
FTP sessions.
c. At the password prompt, type a password between 8 and 12
characters.
Configuring the Passport 8250 device for remote access
Before you can Telnet to the CLI, FTP to the flash file system, and start the
Passport 8250 device from a remote workstation, configure the boot
parameters for the Passport 8250 device using the bootconfig command.
The syntax of the bootconfig command is:
bootconfig [set]
where
[set] modifies one or more boot parameters
Breaker is off. Turn to on.