Nortel Networks Instant Internet 400 Unit - Manual (Page 21)

21
Setting Up the BayStack Instant Internet 400 Unit
Chapter 1
Introduction
This chapter introduces your Instant Internet 400 unit and describes package
contents, available options for your Instant Internet unit, and any requirements
and compatibility issues.
Instant Internet package
The Instant Internet package contains:
• Instant Internet 400 unit
• Depending on the type of connection you ordered, your Instant Internet
package contains one or more of the following connector cables:
— RJ-11 cable (phone cord) for a dial-up connection
— ISDN cable for an ISDN connection
— RJ-45 cable for a 10BASE-T or 100BASE-T Ethernet connection
— RJ-48 cable for a T1 or DDS connection
• Important Notice for the BayStack Instant Internet Version 7.11
(Part number 307603-E)
• Installing the BayStack Instant Internet Management Software Version 7.11
(Part number 209226-B)
Note: If you ordered your Instant Internet unit for use on a token ring
network or with a V.35 or X.21 modem, you must provide the connection
cable. For pinout diagrams for V.35 and X.21 adapter cables, refer to
Appendix B, “Adapter cable pinout diagrams,” on page 53 .