National Instruments Compact FieldPoint Mounting Accessories cFP-21xx - Manual (Page 6)

Compact FieldPoint Mounting Accessories 6 ni.com
Mounting the Controller on a DIN Rail
1. Fasten the DIN rail clip to the
back of the base using a number
2 Phillips screwdriver and the
8-32
× 5/16 in. countersunk
screws shipped with the kit.
Caution If you substitute
other screws for the screws
shipped with the kit, do not
use screws longer than
5/16 in. to fasten the DIN
rail clip to the base.
2. Insert one edge of the DIN rail
into the deeper opening of the
DIN rail clip.
3. Press down firmly on the controller to compress the spring until the clip locks
in place on the DIN rail.