English / a-13, After use, Maintenance schedule – Nilfisk-Advance America 56316025 (R32-C) User Manual
Page 13: Lubricating the machine, Adhancer
ENGLISH / A-13
R28-C, R32-C / BR 800S TRIO EDS
- 56041647 - A-13
fi nished scrubbing, press the Scrub Off Switch (B) twice, this will automatically raise, retract and stop all the machine systems (brush, squeegee,
vacuum, solution and detergent (AXP/EDS models)). Then drive the machine to a service area for daily maintenance and review of other needed service up
To empty the solution tank, remove the Solution Drain Hose (4) from its storage clamp. Direct the hose to a designated “DISPOSAL SITE” and remove the
plug. Rinse the tank with clean water.
To empty the recovery tank, pull the Recovery Tank Drain Hose (21) from its storage area. Direct the hose to a designated “DISPOSAL SITE” and remove
the plug (hold the end of the hose above the water level in the tank to avoid sudden, uncontrolled fl ow of waste water). Rinse the tank with clean water.
Remove the brushes or pad holders. Rinse the brushes or pads in warm water and hang up to dry.
Remove the squeegee, rinse it with warm water and re-install on mount.
Remove the hopper on cylindrical systems and clean thoroughly. Remove from either side of the machine by opening the skirt and tilting the hopper up and
away from housing, then pull out.
Check the maintenance schedule below and perform any required maintenance before storage
Check/Clean Tanks & Hoses
Check/Clean/Rotate the Brushes/Pads
Check/Clean the Squeegee
Check/Clean Vacuum Shut-Off Float
Check/Clean the vacuum motor foam fi lter(s)
Clean Hopper on Cylindrical System
Check Each Battery Cell(s) Water Level
Inspect Scrub Housing Skirts
Inspect and clean Solution Filter
Check Foot/ Parking Brake For Wear & Adjustment
Clean Solution Trough on Cylindrical System
Purge Detergent System
Lubrication - Grease Fittings
* Check Carbon Brushes
* Have Nilfi sk-Advance check the vacuum motor carbon motor brushes once a year or after 300 operating hours. The brush and drive motor carbon brushes
check every 500 hours or once a year.
NOTE: Refer to the Service Manual for more detail on maintenance and service repairs.
Store the machine indoors in a clean dry place. Keep from freezing. Leave the tanks open to air them out.
Turn the Master Key Switch (J) OFF (O) and remove the key.
LUBRICATING THE MACHINE
Once a month, pump a small amount of grease into each grease fi tting on the machine until grease seeps out around the bearings.
Grease fi tting locations are:
Squeegee Caster Wheel Axle
Steering Wheel Shaft Universal joint
Scrub Deck Caster Wheel Swivels (F) qty of 4 zerts (2 per castor).
Once a month, apply light machine oil to lubricate the:
General Pivot Points For the Squeegee, Brush Linkage and Side Skirts
Squeegee mount angle adjustment knob threads