Warning, Caution, English / a-7 – Nilfisk-Advance America 56316025 (R32-C) User Manual
Page 7: Description of the battery condition indicators, Install the batteries, Figure 1
ENGLISH / A-7
R28-C, R32-C / BR 800S TRIO EDS
- 56041647 - A-7
DESCRIPTION OF THE BATTERY CONDITION INDICATORS
The battery condition indicator (K) consists of three lights, a green (L), a yellow (M), and a red (N). The voltage indication will change based on the cutoff level
(standard or alternate) selected in the control unit. The battery voltage ranges for the various indications are listed below:
Green 34.00+ 34.50+
Green & Yellow
Yellow & Red
NOTE: Refer to service manual for selection of alternate cut-off level. Once the low voltage cutout level has been reached (fl ashing red indicator) the batteries
must be FULLY recharged to reset the battery condition indicator. The scrub system will not function until the indicator has been reset.
INSTALL THE BATTERIES
Use extreme caution when working with batteries. Sulfuric acid in batteries can cause severe injury if allowed to contact the skin or
eyes. Explosive hydrogen gas is vented from inside the batteries through openings in the battery caps. This gas can be ignited by
any electrical arc, spark or fl ame.
When Servicing Batteries...
Remove all jewelry.
Do not smoke.
Wear safety glasses, a rubber apron and rubber gloves.
Work in a well-ventilated area.
Do not allow tools to touch more than one battery terminal at a time.
ALWAYS disconnect the negative (ground) cable fi rst when replacing batteries to prevent sparks.
ALWAYS connect the negative cable last when installing batteries.
Electrical components in this machine can be severely damaged if the batteries are not installed and connected properly. Batteries
should be installed by Nilfi sk-Advance or by a qualifi ed electrician.
Turn the Key Switch (J) off (O) and remove the key. Then swing open the Battery Compartment Cover (16).
Using (2) people and an appropriate lifting strap, carefully lift the batteries into the compartment tray exactly as shown. Refer to decal 56015168 battery
See Figure 1. Install battery cables as shown and tighten the nuts on the battery terminals.
Install the battery boots and secure tightly to the battery cables with the supplied tie straps.
Connect the battery pack connector to the machine connector (22) and close the battery compartment cover.