NETGEAR MR814v2 - Manual (Page 46)

Reference Manual for the MR814v2 Cable/DSL Wireless Router
3-10 Wireless Configuration
4. Click Add to add a wireless device to the wireless access control list. The Available Wireless
Cards list displays.
Figure 3-11. Wireless Access menu
5. Click the radio button next to a device on the list and then click Add to add this device to the
list.
Note: You can copy and paste the MAC addresses from the firewall’s Attached Devices menu
into the MAC Address box of this menu. To do this, configure each wireless PC to obtain a
wireless link to the firewall. The PC should then appear in the Attached Devices menu.
6. Be sure to click Apply to save your wireless access control list settings.
To edit a MAC address from the table, click on it to select it, then click the Edit or Delete button.
Configure WEP
To configure WEP data encryption, follow these steps:
Note: When configuring the firewall from a wireless PC whose MAC address is not in
the Trusted PC list, if you select Turn Access Control On, you will lose your wireless
connection when you click on Apply. You must then access the router from a wired PC
or from a wireless PC which is on the access control list to make any further changes.