National Instruments PC-DIO-24 - Manual (Page 69)

PC-DIO-24 Hardware and Software
Configuration Form
___________________________________________________
Record the settings and revisions of your hardware and software on the line to the right of each item. Complete a
new copy of this form each time you revise your software or hardware configuration, and use this form as a
reference for your current configuration. Completing this form accurately before contacting National Instruments
for technical support helps our applications engineers answer your questions more efficiently.
National Instruments Products
• PC-DIO-24 Revision _________________________________________________
• Base I/O Address of PC-DIO-24
(Factory Setting–hex 210)
_________________________________________________
• Interrupt Enable Line of PC-DIO-24
(Factory Setting–PC4)
_________________________________________________
• Interrupt Level of PC-DIO-24
(Factory Setting–5)
_________________________________________________
• Handshaking Mode
(mode 0, mode 1, mode 2)
_________________________________________________
• NI-DAQ or LabWindows/CVI Version _________________________________________________
Other Products
• Computer Make and Model _________________________________________________
• Microprocessor _________________________________________________
• Clock Frequency _________________________________________________
• Type of Video Board Installed _________________________________________________
• DOS Version _________________________________________________
• Programming Language _________________________________________________
• Programming Language Version _________________________________________________
• Other Boards in System _________________________________________________
• Base I/O Address of Other Boards _________________________________________________
• Interrupt Enable Line
of Other Boards
_________________________________________________
• Interrupt Level of Other Boards _________________________________________________