Transport locking screws, Holes for locking screws guard coin – Nikon LS-2000 User Manual

Page 19

Advertising
background image

- 19 -

Setup: Installation

When using the optional SF-200 slide feeder

Once the scanner is installed, slide the front cover open. Using
a coin, remove the transport locking screws from the adapter
slot and side panel and screw them into the holes provided on
the rear panel. The adapter slot contains a guard to prevent
the transport screw from falling into the scan mechanism when
the transport screw is removed. After removing the transport
screw from the adapter slot and screwing it into one of the
holes on the rear of the scanner, remove the guard and store it
in a safe place.

Caution:

Never turn the scanner on with the locking screws

in place. Turning the power on in these circumstances could
damage the scanner.

Note: Replace the locking screws and guard when transporting
the scanner (see “
Maintenance: Transporting the Scanner,”
below).

Transport locking screws

MADE IN JAPAN

100098

SCSI

SCSI

SCSI NB

TERMINATOR

OFF

ON

6

5

4

3

2

1

0

7

100–240V~

0.3–0.2A

50/60 Hz

Holes for locking screws

Guard

Coin

Advertising