Nikon LS-2000 - Manual (Page 28)

- 28 - Using the Scanner: Inserting and Removing Adapters
✔
Cautions
• Wait until the status LED glows steadily or the scanner is off
before inserting or removing adapters. Do not replace
adapters while the scanner is operating.
• If an adapter does not slide in smoothly, remove it from the
adapter slot and try again. Do not use force.
Using the MA-20 S
LIDE
M
OUNT
A
DAPTER
When scanning 35 mm slides, insert the slide adapter into the
scanner, stopping when the adapter is firmly in place. The
adapter should be oriented relative to the scanner as shown in
the illustration below.
Inserting slides
Film has an emulsion surface and a base; when examined under
a light, the emulsion side is dull and the base shiny. Looked at
from the base side, the image is exactly as it would appear in a
printed photograph, while when seen from the emulsion side,
the image is reversed.