Nikon LS-2000 - Manual (Page 45)

- 45 - Using the Scanner: Using the SF-200 Slide Feeder
Removing slides
Slides will be sent to the ejection magazine after scanning. To
remove slides from the ejection magazine, pull back the push
plate and remove the slides. Slides must be removed before
the ejection magazine fills up.
Using the feed-mechanism attachment
Thick mounts (over 2 mm thick) with rounded edges may not
feed properly when used with the SF-200. A removable plastic
part is provided for attachment to the feed mechanism, enabling
the scanner to feed such slides. A special attachment utility
program, provided with the Nikon Scan software that came
with your scanner, is required both when attaching this part to
and removing it from the feed mechanism.
To attach the feed-mechanism attachment, both your scanner
and computer must be on. After inserting the SF-200 into the
scanner as described above, open the Utility folder in the
folder to which you installed Nikon Scan and then double-click
the Attachment Utility icon to start the attachment utility.
The attachment utility window will appear on the desktop. If
more than one scanner is attached to your computer and
powered on, select the scanner to which the SF-200 is attached
from the select a scanner pop-up menu.
Open the SF-200’s magazine cover, pull back the feed push-
plate to the end of its grove, and hook it in the notch so that it
does not spring back to its original position.