Nikon LS-2000 - Manual (Page 43)

- 43 - Using the Scanner: Using the SF-200 Slide Feeder
Loading the feeder
Slides to be scanned are inserted in the feed magazine. To load
the magazine, open the magazine cover, pull back the feed
push-plate to the end of its grove, and hook it in the notch so
that it does not spring back to its original position. Place the
slides in the magazine with the long end of the aperture up and
the emulsion surface facing the push plate (the images in the
slides should be reversed when viewed from the magazine
side). Scanning will be considerably simplified if the slides are all
inserted in the same orientation.
Slides can be loaded into the feed magazine up to the load
mark. Do not attempt to fill the magazine past this point.
Once the feed magazine is loaded, release the push plate from
the notch and slide it back until rests against the slides.
Close the magazine cover. You are now ready to begin scan-
ning. For details on consecutive scanning of multiple slides, refer
to the software reference manual for your platform.
Magazine cover
Push plate
Load mark
Notch
Feed magazine