Nlynx Wireless Gateway - Manual (Page 19)

19
Basic Setup — Print Server
To view and adjust the Wireless Gateway's print server settings, click Print Server in
the command panel at the left edge of your browser window (if the command does not
appear there, click Basic Setup at the top of the window first). Controls in the Print
Server settings panel are explained below.
Print Port
The Print Port Speed control has two possible settings, High and Low. The
default setting is High, which is preferable for most modern printers. Change
the setting to Low only if your printer is antiquated and prints incorrectly at a
High setting.
TCP/IP
The Print Server TCP/IP settings include the IP address and subnet mask used
by the Wireless Gateway on the LAN. These are set through the Broadband
Router settings panel and displayed in the Print Server panel for informational
purposes only. The Print Server panel also shows the Raw Send Port, an
unchangeable setting used by Microsoft Windows 2000 for network-based
printing.
AppleTalk