Nlynx Wireless Gateway - Manual (Page 69)

69
Appendix
Device Utility
Device Utility is a free monitoring program designed for your convenience and may
be found in the CD-ROM shipped together with the Wireless Gateway. It may be used
to detect the existence of various devices on the network, obtain relative information,
change their IP addresses, and upgrade their firmware if necessary.
Installation
Follow these simple steps to install and launch Device Utility on your computer:
1. Insert the CD-ROM in the CD-ROM driver.
2. Launch Setup.exe found in the sub-directory “Device Utility” on the CD-ROM.
3. Follow the instructions appeared on the screen.
4. After the setup is completed, click on “Start” >> “Programs” >> “Device Utility”
>> “Device Utility v*.*” (where *.* is t he version number of the Device Utility)
to launch the software. (Click on “unInstall *.*” instead of “Device Utility v*.*”
to uninstall Device Utility should it be necessary.)
5. A Device Utility application window will appear as illustrated below. At the
bottom of the window these words “Discovering Device …” will appear, followed
by “Ready” in a few seconds. The Device utility is then ready for use.