Nlynx Wireless Gateway - Manual (Page 71)

71
Changing IP Address
Device Utility may be used to change the IP address of a network device. Simply
follow these steps:
1. Click on the name of the device in the Device Name list, and then click on the
button Change IP Address.
2. If the device has a password protection, a password window will appear asking the
user to enter it. Enter the password and click OK. If no password is required, no
password window will appear and you may go to Step 3 directly.
Note: Once the correct password has been entered, it will be stored for your
convenience until you exit from Device Utility and no password entry will
be required again during this session.
3. A Change IP Address window will appear. Enter the new IP address then click
OK. These new values will then be stored in the device.
Firmware Upgrade
Device Utility may be used to upgrade the firmware of a network device. Simply
follow these steps:
1. Click on the name of the device in the Device Name list, and then click on the
button Download Firmware.
2. If the device has a password protection, a password window will appear asking the
user to enter it. Enter the password and click OK. If no password is required, no
password window will appear and you may go to Step 3 directly.
Note: Once the correct password has been entered, it will be stored for your
convenience until you exit from Device Utility and no password entry will
be required again during this session.
3. A Download Firmware window will appear. Enter the path and file name. If you
do not know, click on Browse to select the correct path and file. After making sure
of the correct path and file name, click OK. The device will then download the
new firmware.