Nortel Networks COOLPIX S5100 User Manual
Page 43
31
Using the Flash
Bas
ic Ph
otography an
d Pl
ayba
ck
: A
(Auto)
M
o
de
B
Shooting When the Flash Is Disabled (W) or Lighting Is Dim
• Use of a tripod is recommended to stabilize the camera during shooting. Set
Vibration
reduction (A 129) to Off in setup menu (A 120) when using a tripod to stabilize the camera.
• E may be displayed in the shooting screen. When E is displayed, ISO sensitivity is
automatically increased.
• The noise reduction function may be activated with some shooting conditions such as dim
lighting. More time than usual is required to save images to which noise reduction is applied.
B
Note on the Flash
When using the flash, reflections from dust particles in the air may appear as bright spots in images.
To reduce these reflections, set the flash to W (off).
C
The Flash Lamp
The flash lamp indicates flash status when the shutter-
release button is pressed halfway.
• On: Flash will fire when picture is taken.
• Blinks: Flash charging. Wait a few seconds and try again.
• Off: Flash will not fire when picture is taken.
If the battery is low, the monitor display will turn off, and
remain off, until the flash is fully charged.
C
The Flash Mode Setting
The default flash mode setting varies with shooting mode (
• A (auto): U (auto)
• Scene: varies with the selected scene mode (
• F (smart portrait): U (auto) when
Off is selected for Blink proof; fixed at W (off) when On is
selected for
Blink proof (A 66)
• s (subject tracking): W (off)
The flash cannot be used simultaneously with certain functions. See “Camera Settings that Cannot
Be Applied Simultaneously” (
A 49) for more information.
The flash mode setting applied in A (auto) mode is saved in the camera’s memory even after the
camera is turned off, and reapplied the next time A (auto) mode is selected.
C
Red-eye Reduction
This camera uses advanced red-eye reduction (In-Camera Red-Eye Fix). Pre-flashes are fired
repeatedly at low intensity before the main flash, reducing the red-eye effect. Additionally, if the
camera detects red eye while saving an image, the affected area will be processed to reduce red-eye
before the image is saved.
Note the followings when shooting.
• Because pre-flashes are fired, there is a slight lag between when the shutter-release button is
pressed and when the shutter is released.
• More time than usual is required to save images.
• Red-eye reduction may not produce the desired results in all situations.
• In extremely rare instances, areas not subject to red-eye may be affected by red-eye reduction
processing; in these cases, choose another flash mode and try again.