Napco Security Technologies WI1501A - Manual (Page 2)

THIS MANUAL INCLUDES FEATURES WHICH ARE ONLY AVAILABLE IN THE FREEDOM F-64
CONTROL PANEL FIRMWARE VERSION 30 OR LATER.
NAPCO Security Systems, Inc.
333 Bayview Avenue, Amityville, New York 11701
For Sales and Repairs, call toll free: (800) 645-9445
For direct line to Technical Service, call toll free: (800) 645-9440
Internet: http://www.napcosecurity.com
Refer to accompanying F-64 Programming Instructions (WI1502) for programming information.
IMPORTANT NOTICE
F-64 panel version 30 requires the use of the following version programmer:
• F-64PROG Version 01
Upon entering program mode, the LCD window will flash the control panel firmware version, followed by the pro-
grammer firmware version:
• F-64PROG : [3001]
If Gemini keypads are installed in the system (in addition to the required Freedom F-64TP or F-64TP-H Touch-
pads), the following version keypads must be used:
• GEM-K1CA Version 9B
• GEM-K2AS, Version 7
• GEM-K3DGTL, Version 3
• GEM-K4/K4RF, Version 2
Differences between the GEM-P1664 and the Freedom F-64 Control Panels:
The GEM-P1664 control panel and the Freedom F-64 V30 control panel are identical, except for the following:
• The "Classic" Gemini RP-Series keypads cannot be used with the Freedom F-64 V30 control panel.
• The Perimeter Group Bypass zone feature is exclusive to the Freedom F-64 V30 control panel.