National instruments software, National instruments software -4 – National Instruments Two-Slot Embedded Controller NI PXI-8183 User Manual
Page 12
Chapter 1
Introduction
1-4
ni.com
The NI PXI-8183 consists of the following logic blocks on the
CPU module:
•
The Socket 370 CPU is the socket definition for the Intel Pentium III
processor families.
•
The SO-DIMM block consists of a 64-bit SDRAM socket that can hold
up to 512 MB.
•
The Chip Set GMCH connects to the CPU, SDRAM, and video.
•
The SMB to PXI Trigger provides a routable connection of the
PXI triggers to/from the SMB on the front panel.
•
The Watchdog Timer block consists of a watchdog timer that can reset
the controller or generate a trigger.
•
The Chip Set ICH2 connects to the PCI bus USB, IDE, LPC, and
Ethernet ports.
•
The USB Connector connects the chip set to the Universal Serial Bus
interface.
•
The PXI Connector connects the NI PXI-8183 to the PXI/CompactPCI
backplane.
•
The Keyboard/Mouse block contains the PS/2 keyboard and mouse
interface.
•
The Super I/O block represents the other peripherals supplied by the
NI PXI-8183. The NI PXI-8183 has one serial port and an ECP/EPP
parallel port.
•
The IDE block is dedicated PCI-IDE circuitry providing fast ATA-100
transfers to the internal hard drive. The IDE feature is built into the
chip set.
•
The 10/100 Enet connects to either 10 Mbit or 100 Mbit Ethernet
interfaces.
•
The 2.5 in. hard drive is 40 GB or larger.
National Instruments Software
National Instruments has developed several software kits you can use
with the NI PXI-8183. The software is already installed on your hard drive.
NI-DAQ has an extensive library of functions that you can call from your
application programming environment. These functions include routines
for analog input (A/D conversion), buffered data acquisition (high-speed
A/D conversion), analog output (D/A conversion), waveform generation,