National Instruments Two-Slot Embedded Controller NI PXI-8183 - Manual (Page 21)

Chapter 2 Installation and Configuration
NI PXI-8183 User Manual 2-8 ni.com
• Floppy Drive—You can route the internal signals used for the
3.5 in. floppy drive operation through the pins on the parallel port
connector. Use this setting to operate the NI PXI-8183 controller with
a specialized external floppy drive. Normally, using a Universal Serial
Bus (USB) floppy drive is preferable to this option, which requires a
specially designed drive and cable. (Refer to the
Parallel Port section
of Chapter 3, I/O Information , for pinout information.) Setting this
option to Parallel Port disables normal LPT1 functionality. The
default is Disabled.
• Legacy USB Support—Use this setting to use a USB keyboard and
mouse as if they were standard PS/2-style peripherals. You must enable
this setting to use these devices in operating systems with no USB
support and to boot from a USB floppy or CD-ROM. The BIOS setup
screen always works with USB keyboards regardless of this setting.
Certain real-time applications may require you to disable this setting
to reduce loop time jitter. The default is Enabled.
PXI Setup Menu
Use this menu to control and route certain signals on the PXI backplane.
Normally, you do not need to modify these settings. However, other
sections of this manual may indicate that modifications are necessary
and may lead to unpredictable behavior.
• INTP Routing—You can route INTP to ISA IRQ 14, for use by a
PXI device functioning as a Primary IDE Controller. The default
setting is Not Routed.
• INTS Routing—You can route INTS to ISA IRQ 15, for use by a
PXI device functioning as a Secondary IDE Controller. You also can
route it to the controller’s 21-frame serialized IRQ input, for use by
certain PXI carrier cards. The default setting is Not Routed.
Note If INTS or INTP is routed to an ISA IRQ, you must disable one or both channels of
the integrated IDE/ATA controller for correct operation of this routing.