Jumpers w3, w4, and w5, Jumpers w3, w4, and w5 -8, Table 2-2 – National Instruments SCXI-1161 User Manual
Page 24
Chapter 2
Configuration and Installation
2-8
© National Instruments Corporation
Jumpers W3, W4, and W5
You can use two types of data acquisition boards with the
SCXI-1161-DIO-type boards and MIO-type boards. All three jumpers
have labels indicating the DIO and the MIO configurations. If you want
to use the SCXI-1161 with a DIO-type board, place all three jumpers in
the DIO position, the factory setting. If you want to use the SCXI-1161
with an MIO-type board, place all three jumpers in the MIO position. If
nothing is cabled to the SCXI-1161 rear signal connector, the positions
of these jumpers are irrelevant.
Table 2-2. Configuration of Jumpers W3, W4, and W5 for DIO-Type
and MIO-Type Boards
Jumper
Configuration for DIO-Type
Board (Factory Setting)
Configuration for
MIO-Type Board
W3
W4
W5
MIO
DIO
W3
MIO
DIO
W3
MIO
DIO
W4
MIO
DIO
W4
MIO
DIO
W5
MIO
DIO
W5