NordicTrack NTB39020 - Manual (Page 11)

11
20. Thread an M6 Nut (71) onto the Short Cable (44).
Attach the end of the Short Cable to the “U”-
bracket (37) with an M6 Washer (63) and an M6
Nylon Locknut (66).
Wrap the Long Cable (43) under a 3 1/2” Pulley
(34). Attach the Pulley inside the “U”-bracket (37)
with an M10 x 50mm Button Head Bolt (57) and
an M10 Nylon Locknut (64).
See the inset drawing. The M6 Nylon Locknut
(66) should be threaded onto the Short Cable
(44) so that the end of the Short Cable is nearly
touching the Long Cable (43).
20
66
66
34
63
37
57
64
44
44
43
21. Wrap the Long Cable (43) around a 3 1/2” Pulley
(34). Attach the Pulley and a Cable Trap (36) to
the Center Top Frame (9) with an M10 x 47mm
Button Head Bolt (60), an M10 Washer (62), and
an M10 Nylon Locknut (64). Make sure the
Cable Trap is oriented to hold the Cable in the
groove of the Pulley.
22. Wrap the Long Cable (43) around a 3 1/2” Pulley
(34). Attach the Pulley and a Cable Trap (36) to
the Center Top Frame (9) with an M10 x 47mm
Button Head Bolt (60) and an M10 Nylon Locknut
(64). Make sure the Cable Trap is oriented to
hold the Cable in the groove of the Pulley.
21
22
60
43
9
36
34
62
64
34
43
36
60
9
64
23. Wrap the Long Cable (43) over a 3 1/2” Pulley
(34). Attach the Pulley and a Cable Trap (36) to
the Center Top Frame (9) with an M10 x 47mm
Button Head Bolt (60) and an M10 Nylon Locknut
(64). Make sure the Cable Trap is oriented to
hold the Cable in the groove of the Pulley.
23
43
64
34
36
9
60
43