NordicTrack NTB39020 - Manual (Page 6)

2
3
6
2. Press a 50mm x 100mm Cap (23) into the Right
Frame (3). Insert two M10 x 116mm Carriage
Bolts (53) up into the Right Frame. Note: The
Right Frame has a short weldment in the indi-
cated location; the other side has a long weld-
ment.
Attach the Right Frame (3) to the Base Frame (1)
with two M10 x 70mm Button Head Bolts (52),
two M10 Washers (62), and two M10 Nylon
Locknuts (64). Do not tighten the Locknuts yet.
Attach the Left Frame (not shown) to the Base
Frame (1) in the same manner.
Orient an Upright (4) as shown. Attach the
Upright to the Right Frame (3) with the two M10 x
116mm Carriage Bolts (53) and two M10 Nylon
Locknuts (64). Do not tighten the Locknuts yet.
Attach the other Upright (not shown) to the
Left Frame (not shown) in the same manner.
3. Make sure there is a 60mm Square Cap (22) in
the top of the Center Upright (6).
Orient the Center Upright (6) so that the letters
are on the indicated side. Attach the Center
Upright to the Base Frame (1) with two M10 x
152mm Button Head Bolts (54), two M10
Washers (62), and an M10 Nylon Locknut (64).
Make sure the Washers and Locknut are on
the lower Bolt. Do not tighten the Locknut yet.
64
3
High
Side
Numbers
Short
Weldment
1
62
23
52
52
53
4
64
62
62
54
1
6
22
64
Letters on
this side