NordicTrack NTB39020 - Manual (Page 9)

9
13. Attach the end of the Medium Cable (45) to the
Weight Carriage (11) with an M10 x 22mm Button
Head Bolt (59) and an M10 Nylon Locknut (64).
14. Locate the Short Cable (44). Route the Cable
through the bracket on the Base Frame (1) and
the hole in the Center Upright (6).
Attach a 3 1/2” Pulley (34) inside the bracket on
the Base Frame (1), over the Short Cable (44),
with an M10 x 50mm Button Head Bolt (57) and
an M10 Nylon Locknut (64).
12. Wrap the Medium Cable (45) over another 3 1/2”
Pulley (34). Attach the Pulley inside the Center
Top Frame (9) with an M10 x 165mm Button
Head Bolt (5) and an M10 Nylon Locknut (64).
12
13
14
45
5
34
64
45
64
11
44
64
34
6
1
57
59
9
15. Note: For clarity, the Foot Plate (17) is not
shown in the following steps.
Remove the upper M10 x 152mm Button Head
Bolt (54) used in step 3.
Wrap the Short Cable (44) over a 3 1/2” Pulley
(34). Attach the Pulley inside the Center Upright
(6) with the M10 x 152mm Button Head Bolt (54),
two M10 Washers (62), two Long Spacers (51),
and an M10 Nylon Locknut (64).
15
64 62
51
51
62
34
44
54
1