NordicTrack NTB39020 User Manual
Page 8
8
8.
Attach the Pull-up Bar (10) to the Right Top
Frame (8) with two M10 x 70mm Button Head
Bolts (52), two M10 Washers (62), and two M10
Nylon Locknuts (64). Do not tighten the
Locknuts yet.
Repeat this step with the Left Top Frame (not
shown).
Tighten the M10 Nylon Locknuts (64) used in
steps 2–8.
8
8
10
52
62
64
9.
Locate the Medium Cable (45), which has an
eyelet on each end. Attach the Cable inside the
Center Top Frame (9) with an M10 x 165mm
Button Head Bolt (5) and an M10 Nylon Locknut
(64).
10. Wrap the Medium Cable (45) under a 3 1/2”
Pulley (34). Attach the Pulley and a Cable Trap
(36) between the second set of holes from the top
of the pair of Pulley Plates (33) with an M10 x
50mm Button Head Bolt (57) and an M10 Nylon
Locknut (64). Make sure the Cable Trap is ori-
ented to hold the Cable in the groove of the
Pulley.
9
10
64
5
45
9
45
57
33
33
64
36
34
11. Wrap the Medium Cable (45) over a 3 1/2” Pulley
(34), as shown. Attach the Pulley inside the
Center Top Frame (9) with an M10 x 165mm
Button Head Bolt (5) and an M10 Nylon Locknut
(64).
11
45
5
34
64
9