Nortel Networks 4500 Series - Manual (Page 28)

28 Small form factor pluggable transceivers
CAUTION
Risk of equipment damage
To prevent damage from electrostatic discharge, always wear
an antistatic wrist strap connected to an ESD jack.
Procedure steps
Step Action
1 Disconnect the network fiber cable from the SFP connector.
2 Affix dust covers over the fiber optic bore and connector.
3 Depending on your SFP model, to release the SFP, press the
locking/extractor mechanism.
Your SFP locking/extractor mechanism can be different than the
models shown.
4 Slide the SFP out of the module SFP slot.
If the SFP does not slide easily from the module slot, use a
gentle side-to-side rocking motion while firmly pulling the SFP
from the slot.
5 Store the SFP in a safe place until needed.
ATTENTION
If you discard the SFP, be sure to dispose of it according to all
national laws and regulations.
--End--
Nortel Ethernet Routing Switch 4500 Series
Installation — SFPs and XFPs
NN47205-301 02.01
20 October 2008
Copyright © 2007-2008 Nortel Networks
.