Nortel Networks 4500 Series - Manual (Page 30)

30 10 Gigabit small form factor pluggable transceivers
3 Use the following job aids to determine the appropriate XFP for
your application.
--End--
Job aid: XFP models
XFPs are hot-swappable input/output enhancement components designed
for use with Nortel products to allow 10 Gigabit Ethernet ports to link with
other 10 Gigabit Ethernet ports.
All Nortel XFPs use Lucent connectors (LC) to provide precision keying
and low interface losses.
The following table lists and describes the Nortel XFP models. For
specifications for these XFPs, see
“XFP specifications” (page 47) . Not all
products support all XFPs.
Table 4
XFP models for the Ethernet Routing Switch 4500 Series
Model number Product number Description
10GBASE-SR AA1403005-E5 850 nanometers (nm). The range is up to:
•
22 m using 62.5 micrometer (
µ
m), 160
megaHertz times km (MHz-km) MMF
•
33 m using 62.5
µ
m, 200 MHz-km MMF
•
66 m using 62.5 µ m, 500 MHz-km MMF
•
82 m using 50
µ
m, 500 MHz-km MMF
•
300 m using 50
µ
m, 2000 MHz-km MMF
10GBASE-ZR/ZW AA1403006-E5 1550 nm SMF. The range is up to 80 km.
10GBASE-LR/LW AA1403001-E5 1310 nm SMF. The range is up to 10 km.
10GBASE-LRM AA1403007-E6 1310 nm. Up to 220 m reach over Fiber
Distributed Data Interface (FDDI)-grade
62.5
µ
m multimode fiber. Suited for campus
LANs.
Installing an XFP
Install an XFP to provide a 10 Gigabit Ethernet interface between the
switch and other network devices.
Installing an XFP takes about three minutes.
For translations of the following messages, see “Product safety warnings
and information” (page 16) .
Nortel Ethernet Routing Switch 4500 Series
Installation — SFPs and XFPs
NN47205-301 02.01
20 October 2008
Copyright © 2007-2008 Nortel Networks
.