NEC MULTEOS M40 - Manual (Page 32)

English-28
OSD Controls
- continued
CLOCK
VGA and RGB/HV input only
Press + to expand the width of the image on the right of the screen.
Press - to narrow the width of the image on the left.
CLOCK PHASE
VGA, RGB/HV, DVD/HD
input only
Adjusts the visual “noise” on the image.
H RESOLUTION
DVI, VGA, RGB/HV
input only
Adjusts the horizontal size of the image.
V RESOLUTION
DVI, VGA, RGB/HV
input only
Adjusts the vertical size of the image.
ZOOM MODE
All inputs except for TV Select the aspect ratio of the screen image.
BASE ZOOM
Choose the zoom method
16:9
HDMI, DVD/HD,
VIDEO input only
14:9
HDMI, DVD/HD,
VIDEO input only
DYNAMIC
HDMI, DVD/HD,
VIDEO input only
OFF
CUSTOM
Same aspect ratio as the LCD panel.
14:9
Expands a 4:3 picture to fill the screen in a non-linear (non-proportionate) manner and
some of the image will be lost due to expansion. DYNAMIC is the same as FULL size im-
age when HDTV 1080i signal is input.
Selecting “OFF” will display the image in a 1 by 1 pixel format. (If the input resolution is
higher than a 1920 x 1080 resolution, the image will be scaled down to fit the screen.
Displays an image as large as possible without changing the aspect ratio or cutting off
part of the image.
ZOOM
16:9, 14:9, CUSTOM only
H ZOOM
16:9, 14:9, CUSTOM only
V ZOOM
16:9, 14:9, CUSTOM only
H POS
16:9, 14:9, CUSTOM only
V POS
16:9, 14:9, CUSTOM only
Maintains the aspect ratio while zooming.
Amount of horizontal zoom. Can be adjusted for each BASE ZOOM setting.
Amount of vertical zoom. Can be adjusted for each BASE ZOOM setting.
Horizontal position. Can be adjusted for each BASE ZOOM setting.
Vertical position. Can be adjusted for each BASE ZOOM setting.
INPUT RESOLUTION
VGA and RGB/HV input only
If there is a problem with signal detection, this function forces the monitor to display the
signal at the desired resolution. After selection, execute “AUTO SETUP” if required.
If no problem is detected, the only available option will be “AUTO”.
ADJUST RESET Resets the following settings within the ADJUST menu back to factory setting:
AUTO ADJUST, H POSITION, V POSITION, CLOCK, CLOCK PHASE, H RESOLUTION, V RESOLU-
TION, ZOOM MODE, INPUT RESOLUTION.
AUDIO BALANCE
TREBLE
BASS
PIP AUDIO Selects source of PIP audio.
LINE OUT Selecting “VARIABLE” will enable to control line out level with VOLUME button.
AUDIO RESET Resets “AUDIO” options back to factory settings.
SCHEDULE OFF TIMER Sets the monitor to power off after a length of time between 1 and 24 hours.